| Why Clean
Your Engine? Chances are,
when your engine was new it delivered the power and fuel
efficiency it was designed for. But now, as your engine
accumulates miles, things are happening that are
adversely affecting its performance. Slowly but surely,
your engine is gathering harmful deposits that will
eventually cost you money.
Even though you may follow a routine
service schedule, your driving conditions may be far
from routine. Stop and go driving, prolonged periods of
idling, short trips that don't allow your engine time to
warm up, towing a trailer, the ingestion of airborne
dirt, fuel dilution, water condensation, and oxidized
oil will eventually cause the formation of a thick,
gummy deposit known as sludge. Settling throughout the
engine, sludge will clog oil passages, restricting the
flow of oil to vital engine parts, especially in the
upper valve train areas.
Don't put clean oil in
a dirty engine!
When an engine gets dirty, even regular
oil changes can't help restore its operating efficiency.
The detergent/dispersants in most conventional engine
oils can't handle the abnormal amounts of contamination
found in a "dirty" engine. The new oil becomes dirty
long before it should, losing much of its ability to
lubricate and protect your engine and actually
accelerating the formation of more sludge and varnish.
In this age of longer recommended drain intervals, it is
especially important to have a clean engine before
changing oil. Using AMSOIL Fast Acting Engine Flush when
you change oil is an excellent way to guarantee your
engine stays clean. It has special solvents and cleaning
agents that act fast but gently to remove harmful
deposits that can cost you money in excessive fuel
consumption and mechanical repairs.
AMSOIL Engine Flush is especially recommended for use
before changing to AMSOIL Synthetic Motor Oils, assuring
that these super premium long life oils provide the
maximum protection and service life they are designed to
deliver.
|
The AMSOIL
Formula
for Better Engine Performance |
1) FLUSH:
To quickly clean residual sludge and engine
deposits, AMSOIL Engine Flush is recommended: Change the
oil filter and add the flush (about 10% of the oil
capacity). Idle the engine 15 to 20 minutes, then
immediately drain the old oil and flush.
*Note: Engine Flush is not recommended for motorcycles,
ATV's or small engines.
2) INSTALL:
Remove the old oil filter and replace it with an
AMSOIL EA Oil
Filter. It is a high quality, state-of-the-art
filter specially designed for today's long drain oils.
And for the best possible protection, add an AMSOIL
By-Pass Oil Filter to remove virtually all contaminating
particles.
3) POUR:
Fill the engine's crankcase with the
AMSOIL Synthetic Motor Oil
of the viscosity grade recommended by your vehicle's
manufacturer. AMSOIL Synthetic Motor Oils are highly
resistant to oxidation and provide exceptional
detergent/dispersant properties, helping keep your
engine free of further sludge and varnish build-up.
4) CHANGE:
Replace your present air filter with an
AMSOIL EA Air
Filter. AMSOIL EA Air Filters trap and hold more
dirt than conventional filters and still allow
substantially more air flow. AMSOIL Air Filters deliver
better performance, increased fuel efficiency, and lower
exhaust emissions.
A clean engine
performs better and lasts longer. Clean your engine and
keep it clean with quality AMSOIL products.
|
